Crane Axle GM Dana 60 Front Steer Knuckle Kit

Run up to 1.5" 35 Spline Axle Shafts

Crane Axle Dana 60 Knuckles were designed to handle up to 1.5" 35 Spline Axle Shafts. 

Interlocking Keyed High Steer Arms means No Bolt Sheering

No need to worry about sheered bolts. The Crane Axle High Steer arms are keyed to interlock with the top of the GM Dana 60 Knuckles. This puts the stress that can occur on high steer arms onto the knuckle.

Uses Off the Shelf GM Components in case of a Failure on the Trail

Crane Axle's GM Dan 60 Front Steer Knuckle kit uses all of the of the factory GM components of outer knuckles. In the case of a broken or failed component, you can easily get a replacement locally and continue riding.

100% USA Cast and Machined

We start with the finest domestic grade 8620 chromoly steel and have our Dana 60 Knuckles cast in the USA. This allows for strict quality control and for a better end product. After casting, each part is individually CNC machined for maximum precision. Our process ensures a consistent end product every time.

Our 8620 chromoly parts can take abuse day in and day out. 8620 Alloy Chromooly Steel has a much higher carbon content than mild steel. The higher amount of carbon means increased strength. This material is characterized by a hard outer surface, combined with a ductile interior for higher strength. Minimum properties of 8620 (chrome-nickel-moly) alloy steel; Tensile Strength, psi: 97,000 Yield, psi 57,000.

Includes:

• 2 - Dana 60 Inner C's
• 2 - GM Dana 60 Knuckles
• 2 - Dana 60 High Steer Arms
• Dana 60 Kingpin Component Kit
• All Necessary Hardware
• Crane Dana 60 Inner C's are bored 3" ID standard. Please CALL TO ORDER if you would like them bored to 3.5" ID. (615) 962-9135